Unitec POS4000/V2-Wash Select II - Manual (Page 64)

P O S 4 0 0 0
Document Number: POS4007 38
Document Title: POS4000/V2 WSII Operations Manual
Example to program remote consoles:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "Multiple Unit MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Prog Remote Consoles" appears
[ENTER]
This command will take a few moments to execute (depending upon the number of remote
consoles to program). As the information is being passed to the remote console, verification
messages will be displayed on the POS4000 screen. The last message to be downloaded is
“ACK DWLD Tax Rate”; if you see this message displayed for more than 15 seconds, the
downloading is complete. Press the Clear button.
Note:
Do not attempt to perform any activity at any of the consoles while downloading is in
progress.
4.1.12 Modem rings
This command is used to configure the number of rings that the modem will answer an outside
call. This is for a POS4000 feature that is no longer supported.
4.1.13 E-System setup MENU->
This command is used to configure an E-systems coin box feature setting. If the E-systems coin
box is equipped with change making or has multiple LCD displays (for each wash type) then here
is where you will enable or disable the feature. This sub-menu is not usable on a Hamilton
Autotec system.
4 . 1 . 1 3 . 1 E n a b l e / D i s a b l e C h a n g e
This command is used to Enable or Disable the change-making feature of an E-System coin box.
If your E-System coin box is equipped with change making capability, then you want to have
Change Enabled.
Example to Enable change in an E-system coin box remote consoles:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until E-System setup MENU->" appears
[ENTER]
[MENU UP/DOWN] until "Enab/Disab Change" appears
[ENTER]
[1] [ENTER]
Enable change
Note:
If your system was incorrectly configured for change and you are disabling change, you
must first power down and then power up the entry system before it will function
properly.