beautypg.com

4 set print to display (non printer mode), 5 display pos diags, 7 clear audit counts – Unitec POS4000/V2-Wash Select II User Manual

Page 85: Set print to display (non printer mode), Display pos diags, Clear audit counts

background image

P O S 4 0 0 0

Document Number:

POS4007

59

Document Title:

POS4000/V2 WSII Operations Manual

4.6.4 Set Print To display (Non printer Mode)

This command implemented in Version 6.67 allows the manual control of printing
the customer’s code to the display during a code printing. It is intended for when
the ticket printer connected to the POS4000 is not functioning properly. When Set
print to display is enabled, the customer code will be displayed on the POS4000
main screen for 10 seconds then cleared. The cashier must write this code down
before it clears. While the code is displayed, no other code can be generated. The
cashier must wait for the first customer code to clear before proceeding.

Example to set non-printer mode:

[CMD]
[SERVICE]
[6][2][7][4][7]

(password 4)

(Example to set non-printer mode cont.)

[MENU UP/DOWN] until "Set print to Display" is displayed
[ENTER]
[1] [ENTER]

to enable printing customer codes to display

4.6.5 Display POS Diags

This command is used in troubleshooting the connection to the external POS
device. Enabling it will cause the POS4000 display to show diagnostic messages
that may be useful to technicians or the Engineering division of Unitec. Do not use
this command unless directed to do so by a qualified person.

Example to configure the displaying of POS diagnostic messages:

[CMD]
[SERVICE]
[6][2][7][4][7]

(password 4)

(Example to enable the setting)

[MENU UP/DOWN] until "Display POS Diags" is displayed
[ENTER]
[1] [ENTER]

to enable the displaying of POS diagnostics

4.7 Clear Audit Counts

This command prints an accounting report like the list counts command, but it also clears the
selected counter level after the report is printed.

Three sets of the counters (shift, manager, and auditor) can be cleared. Each level requires a
different password to clear. The shift, manager and auditor counts are cleared using passwords
1, 2, and 5 respectively.

Example to clear the Manager level:

[CMD]
[CLEAR REPORTS]
[MENU UP/DOWN] until "Clear Manager Counts" appears
[ENTER]
[2]

(password 2, depends on level requested)