Unitec POS4000/V2-Wash Select II - Manual (Page 93)

P O S 4 0 0 0
Document Number: POS4007 67
Document Title: POS4000/V2 WSII Operations Manual
Note:
This menu is password protected by the “Code Lockout Password”. This password is
defaulted to 272001.
4.12.1 Lock Console Sales
This function is used to enable or disable the Console code sales. When enabled, no codes can
be printed from the console. No external POS functions will be affected by this feature. Check a
code and Void a code functions are also not affected by this feature.
Example to enable console code sales lockout feature:
[Menu Down] until you see “Code Sales Lockout”
[Enter]
[272001]
(Lockout password )
[ENTER]
Screen should show “Lock Console Sales”
[ENTER]
[1]
1 to Enable (0 to disable)
[ENTER]
4.12.2 Change Lockout Password
This function is used to change the Console Code Lockout password.
Example to Change Lockout Password:
[Menu Down] until you see “Code Sales Lockout”
[Enter]
[272001]
(Default Lockout password)
[ENTER]
Screen should show “Lock Console Sales”
[Menu Up]
Screen should show “Change Password”
[ENTER]
[XXXXX]
Enter new password (up to 8 digits)
[ENTER]
4.13 Check Code Status
This command allows you to check the status of a code. To access this command, press the
[CMD] key followed by the [CHECK CODE] key. The console will prompt you to enter the code to
check. Type the code to check followed by the [ENTER] key. The console will print the status of
the code as either valid, used, previously canceled or not in memory.
If the code is valid, the date/time it was issued and the features associated with are printed. If the
code has been used, the date/time it was redeemed is printed. If the code was previously
canceled (using the void code command), the date/time that it was canceled is printed. If the code
is not found in memory, the date and time of the oldest valid and used codes currently held in
memory will be printed.
Note:
Fleet account codes will not be validated by this function for the security of those
accounts.