Unitec POS4000/V2-Wash Select II - Manual (Page 56)

P O S 4 0 0 0
Document Number: POS4007 30
4 . 1 . 9 . 2 S e t C o i n / B i l l V a l u e s
This command is used to set the value of the coin and bill pulses that are connected to the
interface board at the entrance of the carwash. To select this command scroll through the Cash
Upgrades sub-menu until "Set Coin/Bill Values" appears and then press [ENTER].
Example to set coins as $0.50 and bills as $5.00:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "Cash Upgrades MENU ->" appears
[ENTER]
[MENU UP/DOWN] until "Set Coin/Bill Values" appears
[ENTER]
[5][0]
[ENTER]
[5][0][0]
[ENTER]
Note:
The default buy up mode depends upon the carwash your POS4000 is configured to
operate with
Caution:
This command is NOT available on systems configured to work with the Hamilton
Autotec.
4 . 1 . 9 . 3 S e t D i s p e n s e V a l u e
This command is used to set the value of coins that are dispensed as change by the AUTOTEC
or the E-Systems 4000 at the entrance of the carwash. Unless your POS4000 main console is
used with the Hamilton AutoTec or the Unitec E-4000, this command will have NO effect upon
the operation of your system. To select this command scroll through the Cash Upgrades sub-
menu until "Set Dispense Value" appears and then press [ENTER].
Example to set the value of dispensed coins as $1.00:
[CMD]
[SYSTEM SETUP]
[3]
(password 3)
[MENU UP/DOWN] until "Cash Upgrades MENU ->" appears
[ENTER]
[MENU UP/DOWN] until "Set Dispense Value" appears
[ENTER]
[1][0][0]
[ENTER]
Note: The default value is $0.25. Valid values are 25, 50, 100, and 200.
Document Title: POS4000/V2 WSII Operations Manual