1 system configuration, System configuration – Unitec POS4000/V2-Wash Select II User Manual
Page 48
Document Number:
POS4008-A
22
Document Title:
POS4000/V2 WSII Installation and Operations Manual
4.1 System Configuration
The System Configuration command allows you to configure many aspects of the
console operation to your specification. To select this command press the [CMD]
key followed by the [SYS SETUP] key. You will be prompted to enter password 3.
After entering the correct password, you can scroll through the secondary menu
list that follows:
• Set System Time
• Configure a Group
• Set Code Age Warning
• Set Code Length
• Disable Cashier Key
• Set Serial Baud Rate
• Set Languages
• Set Program Relays
• Cash Upgrades MENU->
o
Set BUYUP Mode
o
Set Coin/Bill Values
o
Set Dispense Value
• External POS MENU ->
o
Set POS Offset
o
Set EXT. POS Type
o
Set POS Max Washes
o
Set Send Code Age
o
Reverse order
• Multiple Unit MENU ->
o
Set Unit Number
o
Controller/Remote
o
Set # Bays/Consoles
o
Prog Remote Consoles
To execute one of the secondary commands, scroll through the secondary menu until the
command of interest is displayed, and then press the [ENTER] key. The final three entries in the
secondary menu each allow access to a sub-menu. In addition to the choices shown for each
sub-menu, there is also an item that allows you to "Return to SETUP MENU".
The following information is provided in the System Configuration Report:
• Software Version and date of release
• Car Wash manufacturer compatibility