Metrohm 789 Robotic Sample Processor XL - Manual (Page 70)

3.2 Configuration
62 Metrohm Sample Processor, Operation
>recall rack
shift position T2 0 mm
Shifting position for sample positions at
Tower 2 *
)
0…325 mm (in mm from upper stop point)
>recall rack
special pos. T1 0 mm
Special position for sample positions at
Tower 1 *
)
0…325 mm (in mm from upper stop point)
>recall rack
special pos. T2 0 mm
Special position for sample positions at
Tower 2 *
)
0…325 mm (in mm from upper stop point)
>recall rack
beaker radius * mm
Effective beaker radius for the sample
positions on the rack
*, 1…100 mm * = any value
This setting is required for an automatic check of the beaker radius, see
p. 58.
>recall rack
beaker sensor: Tower
Selection of the beaker sensor
Tower, SwingH, OFF
The beaker sensor checks the presence of a sample beaker when executing
a MOVE command.
>recall rack
rack offset 0.00°
Correction for the rotation angle of a
sample rack * )
-5.00…0.00…5.00°
* ) All the above lift positions and the rack offset can be set by using the
function.
Special beaker positions
>>recall rack
>>>special positions
Submenu special beaker positions
Open with
Special beaker positions are predefined places on a sample rack that are not
treated as sample positions. They can be occupied by rinsing beakers or
conditioning beakers and selectively addressed during a run sequence. Up
to 16 special beaker positions can be defined per rack. For each spezial
beaker the work position of the lift (tower 1 and 2) and the beaker radius can
be set, see above.
Selection of special beaker
>>>special positions
special beaker 1
1…16
Use
for next higher
level