Metrohm 789 Robotic Sample Processor XL - Manual (Page 65)

3.2 Configuration
Metrohm Sample Processor, Operation 57
3.2 Configuration
CONFIG
Main menu:
configuration
>auxiliaries
• Open submenu with
configuration
>tower 1
• Use < > or < > to move up and down by one
menu item
configuration
>tower 2
• Use or to move to the first or last
menu item
configuration
>rack definitions
• Use to return to operating condition
configuration
>Dosing units
configuration
>RS232 settings
3.2.1 Miscellaneous
configuration
>auxiliaries
Submenu for basic settings
Open the submenu with
>auxiliaries
dialog: english
Select dialog language
english, deutsch,
français, español
>
auxiliaries
display contrast 3
Set display contrast
0…3…7 0 = low contrast
7 = high contrast
>auxiliaries
beeper: ON
Beep for warnings on or off
ON,OFF
> auxiliaries
external Start: off
Switch on external start via Remote line
(Input 7)
on, off
Normally the Sample Processor takes over the complete run control for a
sample series as the "Master". This may be unwanted, particularly if an
automated system has been set up that includes instruments that are not
from Metrohm. This is why the Sample Processor can also be started from
any external instrument via the Remote interface.
With
external Start: ON the run sequences of the Sample Processor will
Use
for next higher
level