Metrohm 789 Robotic Sample Processor XL - Manual (Page 54)

2.4 Connecting up accessories
46 Metrohm Sample Processor, Installation
2.4.7 Magnetic stirrer
A 741 Magnetic Stirrer can be
placed in any position on the stirrer
guide below the sample rack and
moved about as required.
It is connected to the rear panel of
the tower ( connector).
Fig. 25 741 Magnetic stirrer
The 801 Magnetic Stirrer or 804 Titration Stand is connected to an MSB
socket on the rear of the Sample Processor chassis.
2.4.8 Mounting the stand support
An external titration or measuring cell can be mounted on the Sample
Processor by using the 6.2001.070 Stand Support. The stand support is
attached to stirrer guide of the Sample Processor and fixed in position
with the two socket head screws.
Fig. 26 Stand support
• The height and side at which the
cross strut is fixed are adjustable. It
is fixed in position on the rear panel
of the tower with the screw pro-
vided.
• If it is to be mounted on a 789 Ro-
botic Sample Processor XL then the
support rod must be moved back
by 3 cm. A second mounting hole
is provided in the base plate for this
reason.
Sample rack
Guide rail
Cross strut
Socket head
screws
2nd mounting hole