Metrohm 789 Robotic Sample Processor XL - Manual (Page 141)

6.2 Standard methods
Metrohm Sample Processor, Annex 133
9 MOVE 1 : sample
10 LIFT: 1 : work mm
11 DOS: 1.1 : -0.5 mL
12 WAIT: pause 10 s
13 DOS: 1.2 : port mL
14 MOVE 1 : ext.1
15 SCN:Rm : Cond ok
16 WAIT: pause 60 s
17 SCN:Rm : Cond ok
18 CTL:Rm: START device1
19 LIFT: 1 : work mm
20 DOS: 1.1 : endVol mL
21 DOS: 1.1 : compen mL
22 MOVE 1 : spec.1
23 LIFT: 1 : work mm
24 SCN:Rm : Cond ok
>final sequence
1 CTL:Rm: ************1*
2 WAIT: pause 1 s
3 CTL:Rm: INIT
>changer settings
rack name: *
lift rate T1 25 mm/s
lift rate T2 25 mm/s
shift rate 20°/s
shift direction: auto
swing rate T1 55°/s
swing rate T2 55°/s
on beaker error: MOVE
>stirring rates
>Dosing unit def.
>timeout settings
SCAN timeout: OFF min
on SCAN timeout: error
>manual stop
CTL Rmt: STOP device*
CTL RS232:
PUMP: cont.
STIR T1: cont.
STIR T2: cont.
STIR MSB1: OFF
STIR MSB2: cont.
STIR MSB3: cont.
------------
- Move to sample beaker
- Pierce sample vial
- Aspirate sample volume
- Wait for pressure equilibration
- Close Port 1
- Move to KF cell
- Wait for conditioning
- Stabilization of "Cond." condition
- Wait for conditioning
- Start titration
- Pierce KF cell
- Eject sample volume
- Eliminate slack
- Move to parking position
- Move lift to work height
- Wait for end of titration
- Stop titrator
- Wait 1 second for stop impulse
- Initialize Remote interface
Changer settings
Stirring rates
Settings for dosing device
Actions after manual stop
- Stop titrator