Metrohm 789 Robotic Sample Processor XL - Manual (Page 58)

2.5 Start-up
50 Metrohm Sample Processor, Installation
Under >Dosing units :
• Select dosing drive 1…3
• For each port (1…4) of the corresponding Dosing unit set the
max. dosing rate and enter the tubing dimensions, see p. 63ff.
These settings are required for preparing the Dosing unit (with
the PREP function of the DOS command). The dosing rate must
be reduced for viscous liquids.
Under >RS232 settings :
If a PC control software (e. g. TiNet or Tiamo) is used then it may be
necessary to match the transmission parameters of the serial interface
to those of the software, see p. 65ff. However, the default settings are
suitable for data transmission.