Metrohm 789 Robotic Sample Processor XL - Manual (Page 42)

2.3 Data transmission connections
34 Metrohm Sample Processor, Installation
Start commands:
In principle these are the same commands as those given in the previ-
ous section.
Final scan:
In principle these are the same commands as those given in the previ-
ous section, with the addition of:
SCN:Rm : EndMeter waits for end impulse from 781
SCN:Rm : ***11*** "
Sample Processor— 2 x Titrino/Titrandos
B A Titrino
C
D
B A Titrino
C
D
778
789
Control commands:
CTL:Rm : START Device1 starts Titrino/Titrando 1
CTL:Rm : *************1 "
CTL:Rm : START Device2 starts Titrino/Titrando 2
CTL:Rm : ********1***** "
CTL:Rm : START Device* starts both Titrino/Titrandos
CTL:Rm : ********1****1 "
Final scan:
SCN:Rm : End1 waits for end of titration Titrino/Titrando 1
SCN:Rm : ****1*** "
SCN:Rm : End2 waits for end of titration Titrino/Titrando 2
SCN:Rm : *1****** "
SCN:Rm : Ready1 waits until Titrino/Titrando 1 is ready
SCN:Rm : *******1 "
SCN:Rm : Ready2 waits until Titrino/Titrando 2 is ready
SCN:Rm : **1***** "
SCN:Rm : Ready* waits until both Titrino/Titrandos are ready
SCN:Rm : **1****1 "
The combined operation of the Titrino/Titrando/pH meter can also be
carried out without any problems by the same means.
Device 1 Device 2
Cable 6.2141.030