Metrohm 789 Robotic Sample Processor XL User Manual
Page 27
1.7 The keypad
Metrohm Sample Processor, Introduction
19
fined binary pattern ( selection), e.g.
START device 1
,
INIT
etc.
2nd parameter, for RS232 interface
Data string with up to 14 alphanumeric characters (any).
The default value "&M;$G" (for starting Metrohm instruments) can be
set with
3
WAIT
The
is used to insert the WAIT command in a run sequence.
0
DEF
The
tion. Repeated pressing of the
ous settings. In order to change the entry you must first press
Alterations made in this way only apply to manual operation.
DEF settings
0
DEF
DOSRATE
Change dosing rate
• The dosing rate in mL/min can be set separately for each dosing
device, see p. 70.
• Syntax:
DOSRATE
[dosing device] [dosing rate]
0
DEF
FILLRATE
Change filling rate
• The filling rate in mL/min can be set separately for each dosing
device, see p. 70.
• Syntax:
FILLRATE
[dosing device] [filling rate]
0
DEF
COCKMOVE
Direction of stopcock rotation
• For each connected Dosino the direction of rotation of the stop-
cock switching can be defined separately, see p. 70.
• Syntax:
COCKMOVE
[Dosing device] [Direction of rotation]
0
DEF
LIFTRATE
Change lift rate
• The lift speed in mm/s can be set separately for each tower (for 2-
tower models), see p. 68.
• Syntax:
LIFTRATE
[Tower] [Lift rate]