Metrohm 789 Robotic Sample Processor XL - Manual (Page 144)

0
136 Metrohm Sample Processor, Annex
>sample sequence
1 MOVE 1 : sample
2 LIFT: 1 : work mm
3 CTL:Rm: METER mode C
4 CTL:Rm: START device1
5 SCN:Rm : EndMeter
6 LIFT: 1 : rinse mm
7 PUMP 1.1 : 5 s
8 WAIT: pause 3 s
>final sequence
1 MOVE 1 : spec.1
2 LIFT: 1 : work mm
>changer settings
rack name: *
lift rate T1 25 mm/s
lift rate T2 25 mm/s
shift rate 20°/s
shift direction: auto
swing rate T1 55°/s
swing rate T2 55°/s
on beaker error: MOVE
>stirring rates
>Dosing unit def.
>timeout settings
SCAN timeout: OFF min
on SCAN timeout: error
>manual stop
CTL Rmt: STOP device*
CTL RS232:
PUMP: OFF
STIR T1: cont.
STIR T2: cont.
STIR MSB1: cont.
STIR MSB2: cont.
STIR MSB3: cont.
------------
- Move to sample
- Run lift to work height
- Switch ion meter to concentration measurement
- Start measurement
- Wait for measurement
- Runlift to rinse height
- Rinse for 5 seconds with pump
- Allow to drip for 3 seconds
- Move to rinse beaker
- runlift to work height
Changer settings
Stirring rates
Settings for dosing device
Actions after manual stop
- Stop ion meter