Bowers Group Sylvac D100S Readouts - Manual (Page 6)

5
: in MIN/MAX mode: clear the MIN/MAX memory to the current value.
: introduction of parameters or functions for the following keys: Start, Class, Tol, Clear or Enter,
Min/Max, Setup, Preset, Store, Print, Scan and Channel. All these parameters will be stored after
unit has been switched off.
then : introduction of general parameters: function of the external contact, lan-
guage, keyboard lock, sound inhibition, date/time input and save confi-
gurations (up to 12).
: display the Preset value (zero or any value)
then : introduction of a Preset value for the selected channel (for Preset zero,
enter 0).
: 2 functions are available: - hold display
- store value
then : program the store key for hold or store. Enter the number of channels
to be stored, display or delete values in memory.
: printout of the following: measure, values after scanning, statistics, memorized values on
RS232 and Centronics outputs.
then : choice of RS232 transmission parameters and RS232/Centronics out-
put format
and : display the program version (firmware).
: scan a preprogrammed number of channels and display part OK, rework or reject, according
to the tolerances introduced for each channel.
then : define the first and last channel of the scan; possibility to stop on one
or several channels
and : activate/deactivate the step by step scan (stop on each channel).
: choice of one channel, a channel combination (A+/-B or A+/-B+/-C), the measuring direction
or a multiplication factor.
then : allocate a probe to a specific channel, specify an OptoRS simplex or
duplex channel.