Bowers Group Sylvac D100S Readouts - Manual (Page 35)

34
1.6.14 PRINT KEY
Printing of values through:
- Centronics output, identical to parallel port of PC (LPT1 or 2). This output does not need to be set up and allows
connection of practically all printers on market. Different printing formats are generated by unit D100S: 80, 40 or 15
columns.
- Output RS-232-C, in accordance with transmission parameters selected for this function.
A in reverse video is displayed on the top right corner of display during RS-232-C/Centronics transmission. If the
channel has no installed probe (NO PROBE on display), 999.9 is transmitted.
It is also possible to configure the external contact (foot pedal) for the RS-232-C/Centronics output (refer to Section
1.6.11).
Setting RS232 transmission parameters and Centronics/RS-232-C output format:
1/ press 2/ then
The following will be displayed:
The 1st menu sets RS-232-C transmission parameters.
The 2nd menu selects the RS-232-C/Centronics output format according to
which peripheral is being used.
2.1/ RS232 input/output parameters:
Default parameters (after a reset): 4800 bps, 7 bits, even parity, CR
2.1.1/ transmission speed: 300, 600, 1200, 2400, 4800, 9600 and 19200 bps.
By pressing the key the preceding menu will be displayed.
By pressing the key the next menu will be displayed (without changing previous choice).
2.1.2/ word length: on 7 or 8 bits.
2.1.3/ parity control: No parity, even or odd.
2.1.4/ end characters: CR (Carriage Return) or CR + LF (Carriage Return + Line Feed) or LF only. A printer with auto LF
mode needs only CR. If CR + LF is sent in this case, a supplementary empty line is printed at each carriage return. With
a connection to an IBM PC or compatible select CR only.
Enter the choice :
1 : RS232 config.
2 : Peripheral
P