Bowers Group Sylvac D100S Readouts - Manual (Page 20)

1.6.7 TOL KEY
Displays or removes tolerance indicators:
indicates a measured value smaller than the nominal dimension + negative tolerance on the external mea-
surement or smaller than the nominal dimension + positive tolerance on the internal measurement.
indicates a measured value inside the limits of tolerances.
indicates a measured value larger than the nominal dimension + positive tolerance on the external measu-
rement or larger than the nominal dimension + negative tolerance on internal measurement.
This indication is also transmitted to the corresponding optocoupler output for external command purposes (refer to
Section 1.8.3).
Each channel has its own tolerances.
Input of nominal dimension and tolerances:
1/ select the channel
2/ press
3/ then
The following will be displayed (the current nominal dimension is displayed):
The key allows you to quit the tolerances input.
4/ input nominal dimension.
Wrong value entered can be cancelled by pressing
.
The value is entered as described in Section 1.3.3. (Input of values).
5/ confirm by pressing
The following will be displayed:
CHANNEL 1
Enter nominal size :
12.6 IN
Tol. + :
0.02 IN
CHANNEL 1
Enter nominal size :
8.45 IN
19
● <
●
> ●