Bowers Group M&W Large Digitronic Workshop Caliper 150 Series - Manual

For more information visit www.moore-and-wright.com Partners in Precision
CALIPER INSTRUCTIONS
Large Digitronic Workshop Caliper 150 Series
Please carefully review these instructions to ensure proper and accurate use of your new Digitronic Caliper.
Function
ON/OFF: Power on/off switch
ABS/INC: Relative/absolute measurement
ZERO: Zero setting button
mm/in: metric/inch conversion
SET: presetting button
HOLD: data hold button
Instructions
• Operating Condition:
Temperature:
5-40°C
Relative Humidity: ≤80%
• Prevent any liquid from contacting the protective sticker
• Never apply voltage (e.g. Engraving with an electrograph) on any part of this Caliper for fear of damaging the circuit
• Preset a starting point of measurement correctly (please refer to Operations).
Unless presetting, do not press the “SET” button purposely for fear of measurement error
Technical Specifications
• Resolution: 0.01mm / 0.0005"
• Repeatability: 0.01mm / 0.0005"
• Accuracy: 0-600mm: +/-0.07mm
• Maximum measuring speed: 3m per second
• Battery: CR 2032 3V Lithium Battery
Instructions of Data Output
• Preset zero and metric/inch system
• Connect the end of the interface cable to the computer. The other to the data output port of this Caliper
• Start this Caliper and software
• Move the slider to the position you want and press the button on control box for data output
• Battery life: approx. 1 year
Battery Replacement
Once display begins flashing or even no display, slide the cover open as the arrow shows and replace with a new battery (CR 2032)
Note:
• The positive pole of the battery must face out
• Please preset the starting point over again after battery replacement
Electronics
Data
Output
Battery
Cover
Slider
External Measuring Faces
Internal Measuring Faces
Fine Adjustment
Slider Scale
Locking
Screw
MW150-DDL_Manual_A4.indd 1 21/05/2013 08:07