Bowers Group Internal Spline measurement - Manual

Bowers Metrology Ltd, 32 Leeds Old Road, Bradford, England, BD3 8HU
Tel :(0044) 01274 223456 Fax :(0044) 01274 223444
Email : [email protected]
BOWERS METROLOGY
SPECIAL
APPLICA
TIONS
Subject : Internal Spline Measurement
The following features can be inspected using Bowers spline heads (also used
for checking internal gears) :
• Dimension between pins
• Minor diameter
• Major diameter
• 2 or 3 point contact
• 3-point contact anvils can be machined to suit odd spacing (e.g. 35 teeth)
• Between pin dimension anvils are wire-eroded for robustness
• Rapid inspection
• Can be supplied as ball contacts or a pin/ball combination for checking taper
• Odd tooth splines can be checked using either the 2-point or 3-point system
for between pin dimension
• Can be manufactured / adapted for use with any past or present Bowers
digital system
• 10 mm - 300 mm
• 3/8” - 12"
• Generally power transmission manufacturers, automotive companies
suppliers of clutch components, universal joints, stub-axles etc.
• For details, please contact your sales office or email us at Bradford
• Details of the feature to be measured
• The digital system required (XTD / XTPG / Superbore / BS / BSHM )
• Between-pin dimension
• Number of teeth
• Major / minor diameter
• Whether setting rings are also required
If an order is received, please provide a drawing of the part to enable us to ensure that all
details are correct before proceeding to manufacture.
Details
Head features
Range available
Customer profile
Information required
3-point 2-point
Pitch diameter Minor diameter Major diameter