Bowers Group Sylvac D100S Readouts - Manual (Page 43)

42
2.2.4/ Format for 15 column printer: for small portable printers, battery or accumulator powered (e.g. EDP5000 or
SP1).
As previously, the unit requests the time needed to print one line. A header cannot be entered here.
a/ in normal mode, the measurements are printed as in computer format, but are preceded by the channel number. In
tolerance mode, the difference between the nominal dimension and the measurement is printed:
1
9.716
2+3 15.434
b/ in scanning mode, the following is printed (in tolerance mode, the difference between the nominal dimension and the
measurement is printed):
WORKPIECE 4 <
1.
9.716
2. 12.54
3. 2.008
c/ printing of statistical values: as per computer format but with the possible addition of stored values.
d/ printing of stored values: they are preceded by the store number (figure from 1 to N):
1.
9.999
2. 9.998
3. 10.002
4. 10.000
3/ Remote command of D100S unit: practically all the functions of he D100S unit are remote controllable from a com-
puter through input RS232, according to the following general method:
- the first 3 letters of functions are used for the remote command. For example, if a measured value is required from the
computer, the first 3 letters of Print are transmitted, i.e. PRI.
- any number of spaces can be inserted anywhere, except inside numbers.
- command characters may be in upper or lower case (the latter are ASCII coded).
- On/Off functions like analog scale or tolerances indicators are activated with the first 3 letters of the function, followed
by ON or 1. They are disabled with OFF or 0 (= zero and not the letter O).
For example TOL ON displays tolerances indicators, as does TOL 1.
There should be no delay between characters in remote command word.
Words used for remote commands:
- PRI or ? or P (PRINT) = print out of the displayed value. In scanning mode: output of scanned values.
- CHA+ (CHANNEL) = selects positive measuring direction of the indicated channel.
- CHA- = selects reverse video measuring direction of the indicated channel.
- CHA3 = selects channel 3.
- CHA-2 = selects channel 2, reverse video measuring direction.
- CHA+1-2+ = selects channel 1 minus channel 2, both channels with positive measuring direction.
- CHA*2 = establishes diameter function of the selected channel.
- CHA*1 = establishes radius function (normal) of the selected channel.
- CHA*1.5 = 1.5 multiplication factor
- CHA? or CHA PRI = identifies the direction of measurement (+/-) followed by the active channel.
- CHA2=1 = channel 2 assigned to probe 1
- CHA1=1RS = channel 1 assigned to RS232 on input 1
- PRE (PRESET) = displays the stored preset value.
- PRE 123.4567 = memorize and display preset value.
- PRE ? or PRE PRI = unit sends memorized preset value.