Restoring the factory settings (factory reset), Factory settings, 86 appendices – Boss Audio Systems GS-10 User Manual
Page 86: Tuner, Direct patch, System, Midi, Others
86
Appendices
Restoring the Factory
Settings (Factory Reset)
Restoring the GS-10 to the settings made at the factory is
referred to as “Factory Reset.”
Not only can you return all of the settings to the values in
effect when the GS-10 was shipped from the factory, you can
also specify the range of settings to be reset.
fig.10-040
1. Turn off the power.
2. While holding down PREAMP/SPEAKER CHANNEL
SELECT [A] and [B], turn on the power.
The Factory Reset range setting screen appears in the
display.
fig.10-050d
* To cancel Factory Reset, press [EXIT].
3. Press PARAMETER [
] [
] to move the cursor,
and rotate the PATCH/VALUE dial to specify the range
of settings you want to restore to factory settings.
System:
System parameters, Harmonist scales, Auto Riff phrases,
and Preamp/Speaker, Overdrive/Distortion, and Wah
Custom Edit parameter settings.
U001–U100:
Settings for Patch Number U001 through U100.
4. If you want to proceed with the factory reset, press
[ENTER].
The specified range of data will be returned, and return
to the Play screen.
Factory Settings
Tuner
Tuner Pitch:
A= 440 Hz
Tuner Output:
Bypass
Output Select
OUTPUT Select:
Line/Phones
Direct Patch
Direct Patch 1/2/3/4:
U001/U002/U003/U004
System
LCD Contrast:
16
Patch Extent:
P200
Assign Hold:
On
Knob Mode:
Immediate
EXP PDL Func:
Auto
CTL1 Func:
Assign 1-8
CTL2 Func:
Assign 1-8
MIDI
RX Channel:
1
Omni Mode:
Omni On
TX Channel:
Rx
Device ID:
17
Sync Clock:
Auto
Remote Ctrl:
Advanced
KnobCtrlOut:
On
PC Out:
On
EXP PDL Out:
CC#7
CTL1 Out:
Off
CTL2 Out:
Off
Map Select:
Fix
USB
Output Level:
100
Input Level:
100
Monitor Cmd:
Disable
Dir Monitor:
On
Output Mode:
Stereo (L/R)
Driver Mode:
Advanced
Std.Drv Func:
Audio
Others
Speaker ON/OFF:
ON
Mic Gain:
50
4
3
3
2
+ POWER
Factory Reset range