Boss Audio Systems GS-10 - Manual (Page 152)

152
Installing & Setting Up the Driver (Macintosh)
The About Quick Setup dialog box will appear.
fig.11-520
* If the dialog will not appear, select “Quick Setup” from the Configuration menu.
7.
Click [Continue].
* If the dialog box does not show “GS-10 Driver,” check whether the GS-10 is connected correctly, and start up
FreeMIDI Setup once again.
8.
In the dialog box that appears, set “Studio Location:” to “GS-10,GS-10 Port.” For
the “Cable” field located below it, choose Cable 1 and click [>>Add>>].
fig.11-521
9.
Repeat step 8 up to Cable 2.
10.
When settings are complete, click [Done].
A setting window will appear.
11.
In the setting window, change the device name indicating the MIDI device
connected to the GS-10 as follows.
Click the device name, and you will be able to edit it.
Device 1: GS-10 MIDI IN,OUT
Device 2: GS-10 CONTROL
fig.11-530
12.
From the File menu, select [Save], and save your settings.
13.
Verify that MIDI transmission and reception occur correctly.
From the MIDI menu, choose “Check Connections.”
If a MIDI sound module is
connected to the GS-10, the
following step will cause a
relatively loud sound to be
produced by the sound
module, so it is a good idea to
turn down the volume on the
sound module first.