Boss Audio Systems GS-10 - Manual (Page 49)

49
Chapter 4 Introduction to Effects and Parameters
Section 4
SL (Slicer)
This consecutively interrupts the sound to create the
impression that a rhythm backing phrase is being played.
Parameter Value
Pattern P1–P20
Rate 0–100, BPM –BPM
Trigger Sens 0–100
Pattern
Select the slice pattern that will be used to cut the sound.
Rate
Adjust the rate at which the sound will be cut.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased).
When setting to BPM, press PARAMETER [
] to display
the Master BPM settings screen.
Trigger Sens (Trigger Sensitivity)
Adjust the sensitivity of triggering. With low settings of this
parameter, softly picked notes will not retrigger the phrase
(i.e., the phrase will continue playing), but strongly picked
notes will retrigger the phrase so that it will playback from
the beginning. With high settings of this parameter, the
phrase will be retriggered even by softly picked notes.
AR (Auto Riff)
This allows you to automatically produce a phrase simply by
picking a single note. This can be used to easily play
extremely rapid phrases.
* Reception of large amounts of MIDI data while Auto Riff is
playing may result in disturbances in the sound.
Parameter Value
Phrase Preset1–Preset30,
User1–User10
Loop Off, On
Tempo 0–100, BPM –BPM
Sens 0–100
Key C (Am)–B (G#m)
Phrase = Preset
Attack 0–100
Hold Off, On
Effect Level 0–100
Direct Level 0–100
(User Phrase)
User 1–10
IN C–B
STEP 1–16
OUT C–B (±2 octave), -, end
Phrase
Select the phrase. User-programmed phrases are used when
User 1–10 is selected.
Loop
If “Loop” is turned “On,” the phrase will be played back
continuously.
Tempo
Adjust the speed of the phrase.
* When set to BPM, the value of each parameter will be set
according to the value of the Master BPM (p. 54) specified for
each patch. This makes it easier to achieve effect sound settings
that match the tempo of the song (synchronizing the cycle to
one-half or one-fourth of the BPM when the set cycle rate is
increased). When setting to BPM, press PARAMETER
[
] to display the Master BPM settings screen.
Sens (Sensitivity)
Adjust the sensitivity of triggering. With low settings of this
parameter, softly picked notes will not retrigger the phrase
(i.e., the phrase will continue playing), but strongly picked
notes will retrigger the phrase so that it will playback from
the beginning. With high settings of this parameter, the
phrase will be retriggered even by softly picked notes.
No retriggering occurs when the value is set to “0.”