Boss Audio Systems GS-10 - Manual (Page 56)

56
Chapter 5 Creating Original Effects Types (Customize)
Customizing the Speakers
You can make three different sets of settings, Custom 1 and
Custom 2.
* The sound of any patch that uses Custom 1 or 2 will be altered
if the custom settings are edited.
1. Press the PREAMP/SPEAKER On/Off switch to display
the PREAMP/SPEAKER effect screen.
2. Press PARAMETER [ ] [ ] to call up the SP
Type parameter.
3. Rotate the PATCH/VALUE dial to call up “Custom 1”
or “Custom 2.”
fig.05-030d
4. Press PARAMETER [ ] [ ] to show the custom
parameters.
fig.05-040d
5. Rotate the PATCH/VALUE dial to change the setting’s
value.
6. Repeat Steps 4 and 5 as needed.
7. Press [EXIT] to return to the Play screen.
Parameter Value
Speaker Size 5”–15”
Color Low -10–+10
Color High -10–+10
Speaker Num x1, x2, x4, x8
Cabinet Open, Close
Speaker Size
Selects the size of speaker.
Color Low
Adjusts the speaker section’s low-frequency tone.
Color High
Adjusts the speaker section’s high-frequency tone.
Speaker Num (Speaker Number)
Sets the number of speakers.
Cabinet
Selects the speaker cabinet type.
Open:
This is an open-backed cabinet.
Close:
This type of cabinet features an enclosed rear panel.
Customizing Overdrive and
Distortion
You can make three different sets of settings, Custom 1,
Custom 2, and Custom 3.
* The sound of any patch that uses Custom 1, 2, or 3 will be
altered if the custom settings are edited.
1. Press the OD/DS On/Off switch to display the OD/DS
effect screen.
2. Press PARAMETER [ ] [ ] to call up the Type
parameter.
3. Rotate the PATCH/VALUE dial to call up “Custom 1,”
“Custom 2,” or “Custom 3.”
fig.05-050d
4. Press PARAMETER [ ] [ ] to show the custom
parameters.
fig.05-060d
5. Rotate the PATCH/VALUE dial to change the setting’s
value.
6. Repeat Steps 4 and 5 as needed.
7. Press [EXIT] to return to the Play screen.
Parameter Value
Type OD-1, OD-2, CRUNCH, DS-1,
DS-2, METAL-1, METAL-2,
FUZZ
Bottom -50–+50
Top -50–+50
Low -50–+50
High -50–+50