Boss Audio Systems GS-10 - Manual (Page 63)

63
Chapter 6 Setting the External Pedal Functions
Section 6
Source
fig.06-090d
This sets the controller (source) that affects the target
parameter.
Controllers that can be selected as the source are shown
below.
EXP PEDAL
Expression pedal connected to the EXP PEDAL/CTL 1, 2
jack.
CTL 1, CTL 2
Foot switch connected to the EXP PEDAL/CTL 1, 2 jack.
MIDI CC# 1–31, 64–95
Control Change messages from an external MIDI device (1–
31, 64–95)
Source Mode
fig.06-100d
This determines whether the control pedal will function as a
momentary type switch (such as the optional FS-5U).
Normal
The normal state is Off (minimum value), with the switch On
(maximum value) only while the foot switch is depressed.
Toggle
The setting is toggled On (maximum value) or Off (minimum
value) with each press of the foot switch.
* Set this to “Normal” when a latch-type foot switch (such as
the optional FS-5L) is connected, or when selecting something
other than a foot switch as the controller.
Active Range
fig.06-110d
This sets the operational range within which the value of the
setting changes when an expression pedal or other controller
that changes the value consecutively is used as the source. If
the controller is moved outside the operational range, the
value does not change, it stops at “minimum” or
“maximum.”
(Example)
With Act. Range Lo: 40, Act. Range Hi: 80
fig.06-120
fig.06-130
* When using a foot switch or other on/off switching controller
as the source, leave these at “Lo: 0” and “Hi: 127.” With
certain settings, the value may not change.
maximum value
minimum value
0 40 80 127
Target
Max
Target
Min
Act.Range
Lo
Act.Range
Hi
Off
On
Off
Center
value
On
0 40 80 60 127
Act.Range
Lo
Act.Range
Hi