Boss Audio Systems GS-10 - Manual (Page 30)

30
Chapter 4 Introduction to Effects and Parameters
When CUSTOM 1–3 is selected for Type
You can set the following parameters when Type is set to
CUSTOM.
“Customizing the COSM Amps” (p. 55)
EDIT CUSTOM PRE 1–3
Parameter Value
Type JC Clean, TW Clean, Crunch,
VO Lead, BG Lead,
MS1959 Stk, Modern Stk
Bottom -50–+50
Edge -50–+50
Bass Freq -50–+50
Treble Freq -50–+50
Preamp Low -50–+50
Preamp High -50–+50
Gain
Adjusts the distortion of the amp.
Bass
Adjusts the tone for the low frequency range.
Middle
Adjusts the tone for the middle frequency range.
Treble
Adjusts the tone for the high frequency range.
Presence
Adjusts the tone for the ultra high frequency range.
Level
Adjusts the volume of the entire preamp.
* Be careful not to raise the Level setting too high.
Bright
Turns the bright setting on/off.
Off:
Bright is not used.
On:
Bright is switched on to create a lighter and crisper tone.
* Depending on the “Type” setting, this may not be displayed.
Gain SW
Provides for selection from three levels of distortion: Low,
Middle, and High. Distortion will successively increase for
settings of “Low,” “Middle” and “High.”
* The sound of each Type is created on the basis that the Gain is
set to “Middle.” So, normally set it to “Middle.”
SP Type (Speaker Type)
When Custom 1–2 is selected for SP
Type
You can set the following parameters when SP Type is set to
Custom 1–2.
“Customizing the Speakers” (p. 56)
Off This turns off the speaker simulation.
Original
This is the built-in speaker of the amp you
selected with “Type.”
1x8”
This is a compact open-back speaker cabi-
net with one 8-inch speaker.
1x10”
This is a compact open-back speaker cabi-
net with one 10-inch speaker.
1x12”
This is a compact open-back speaker cabi-
net with one 12-inch speaker.
1x15”
This is a compact open-back speaker cabi-
net with one 15-inch speaker.
1x18”
This is a compact open-back speaker cabi-
net with one 18-inch speaker.
2x12”
This is a general open-back speaker cabinet
with two 12-inch speakers.
2x15”
This is a general open-back speaker cabinet
with two 15-inch speakers.
4x10”
This is an optimal speaker cabinet for a
large enclosed amp with four 10-inch
speakers.
4x12”
This is an optimal speaker cabinet for a
large enclosed amp with four 12-inch
speakers.
8x10”
This is a double stack of two cabinets, each
with four 10-inch speakers.
8x12”
This is a double stack of two cabinets, each
with four 12-inch speakers.
Custom 1 Custom speaker 1
Custom 2 Custom speaker 2