Boss Audio Systems GS-10 - Manual (Page 150)

150
Installing & Setting Up the Driver (Macintosh)
11.
From the Edit menu, select “OMS MIDI Setup”. In the OMS MIDI Setup dialog
box that appears, check “Run MIDI in background,” and click [OK].
fig.11-460
12.
Verify that MIDI transmission and reception occur correctly.
From the Studio menu, choose [Test Studio].
fig.11-470
13.
If a MIDI sound module is connected to the GS-10’s MIDI OUT connector, click
the GS-10 MIDI IN,OUT icon in the Studio Setup window.
If you hear sound, the settings have been made correctly.
fig.11-480
* GS-10 MIDI IN,OUT corresponds to the GS-10’s MIDI IN,MIDI OUT. GS-10 CONTROL corresponds to
the GS-10’s control port.
14.
After you have verified this, and exit OMS Setup.
15.
Make MIDI device settings on your sequencer software.
For details on settings, refer to the manual that came with your software.
→ Next, you need to install the ASIO driver (p. 154).
If a MIDI sound module is
connected to the GS-10, the
following step will cause a
relatively loud sound to be
produced by the sound
module, so it is a good idea to
turn down the volume on the
sound module first.