Boss Audio Systems GS-10 - Manual (Page 26)

26
Chapter 3 Saving the Tones You Have Created
Exchanging Patches
On the GS-10, you can “swap” or exchange the positions of
two User patches. The following explains how this is done.
fig.03-050
1. Select the exchange source patch.
* Refer to “Patch Change” (p. 18).
2. Press [WRITE].
3. Press PARAMETER [ ].
The screen for specifying the exchange-destination patch
number appears in the display.
fig.03-060d
4. Rotate the PATCH/VALUE dial to select the exchange
destination User patch.
* To cancel the exchange, press [EXIT]. The Play screen returns
to the display.
5. Press [WRITE].
The patch stored in the exchange source memory
location and the patch stored in the exchange destination
memory location are exchanged, and you’re returned to
the Play screen.
Initializing Patches
You can return (initialize) the User patches to their original
standard settings.
fig.03-061
1. Select the User patch you want to initialize.
* Refer to “Patch Change” (p. 18).
2. Press [WRITE].
3. Press PARAMETER [ ] twice.
The screen for specifying the initialize-destination patch
number appears in the display.
fig.03-062d
* You can use the PATCH/VALUE dial to change the selection
of the User patch to be initialized.
* To cancel the initialization, press [EXIT]. The Play screen
returns to the display.
4. Press [WRITE].
The GS-10 switches to the initialized patch, and the Play
screen returns to the display.
* The tones stored in patches are lost once the initialization is
executed.
2,5
4 3
Exchange-destination patch
2,4
3
User patch to be initialized