Boss Audio Systems GS-10 - Manual (Page 61)

61
Chapter 6 Setting the External Pedal Functions
Section 6
Manual Settings
Here, you can individually determine which controller is to
control which parameter.
fig.06-013
1. Press [ASSIGN].
2. Press PARAMETER [ ] [ ] to select one of the
Assigns from Assign 1–8.
3. Press [ASSIGN] to set the selected Assign to “On.”
Each time [ASSIGN] is pressed it alternately switches
this on and off. “ASSIGN” flashes in the display when
the Assign is switched on.
* Always set any Assign that is not going to be used to “Off.”
4. Press PARAMETER [ ] [ ] to display the
following screens.
fig.06-020d
5. Rotate the PATCH/VALUE dial to change the setting’s
value.
6. Repeat Steps 4 and 5 as needed.
7. To use other Assigns, repeat Steps 2–6.
Even when using this procedure, the settings selected in
Step 6 are maintained as is and carried over to the Quick
Settings for the next effect.
8. To save the settings, use the Write procedure (p. 25).
Press [EXIT] to return to the Play screen.
Target
fig.06-040d
This sets the parameter to be affected. The parameters that
you can select as the target are shown below.
Effect On/Off
Effect’s Parameters
Switches on/off the effect indicated in the screen and
controls the effect’s parameters.
MST: Patch Level
Controls the patch volume.
MST: Master BPM
Controls the Master BPM.
TUNER On/Off
Turns the tuner on and off.
Master BPM(Tap)
Controls the Master BPM using tap input.
Delay Time(Tap)
Controls the delay time using tap input.
Remote Strt/Stop
Starts and stops the recorder, sequencer, or other such device
connected to the GS-10.
Patch Level Inc1
Increases the patch volume level in increments of 10 units.
Patch Level Inc2
Increases the patch volume level in increments of 20 units.
Patch Level Dec1
Decreases the patch volume level in increments of 10 units.
Patch Level Dec2
Decreases the patch volume level in increments of 20 units.
CH Select Inc
Switches the preamp channel in the following order: A → B
→ C → A...
CH Select Dec
Switches the preamp channel in the following order: C → B
→ A → C...
1,3
5 2,4
Target
Target value range: Min
Target value range: Max
Source
Source Mode
Active Range Low
Active Range High