Boss Audio Systems GS-10 - Manual (Page 20)

20
Chapter 2 Creating Your Own Favorite Tones (Patches)
USB (Bass):
You can add effects to the signals input from the USB
connector (for sounds in the bass and similar registers).
Signals from GUITAR/BASS INPUT and MIC INPUT
are disregarded, and the signals input to the GS-10 from
the AUX INPUT connector are mixed with the effect
output.
fig.02-110
* After setting INPUT SELECT to USB (Bass), you can press
PARAMETER [ ] to set the USB input level (p. 78).
AUX:
This setting is used when selecting the input signal from
the AUX INPUT connector. Signals input from the
GUITAR/BASS INPUT and MIC INPUT are
disregarded, and the signals input to the GS-10 via USB
are mixed with the effect output.
fig.02-120
Setting the Mic Input Level
(MIC GAIN)
This sets the mic input level when INPUT SELECT is set to
Microphone.
* The mic gain setting is a global setting used by all patches.
1. Press PARAMETER [ ].
The MIC GAIN settings screen appears in the display.
fig.02-130d
2. Adjust the gain by turning the PATCH/VALUE dial
while picking up sounds with the mic.
Adjust the level so that the level meter does not fluctuate
beyond the maximum allowable level.
fig.02-140d
* Set the volume for the sound being miked (acoustic guitar,
vocals, etc.) to the level to be used in performance.
* Setting the mic gain too high may result in oscillation.
3. Press [EXIT] to return to the Play screen.
D/A
MULTI
EFFECTS
OUTPUT
GUITAR
AMP OUT
PHONES
AUX
INPUT
USB
DIGITAL
OUT
L
R
D/A
OUTPUT
GUITAR
AMP OUT
PHONES
GUITAR/
BASS
MIC
INPUT
AUX
INPUT
USB
DIGITAL
OUT
L
R
A/D
MULTI
EFFECTS