Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 38)

Drive Installation 2-3
7000 “B” Frame 7000-UM150I-EN-P – June 2013
Overhead Lifting
1. Attach rigging to the lifting angles on the top of the cabinetry.
A T T E N T I O N A T T E N T I O N Ensure that the load rating of the lifting
device and rigging is sufficient to safely
raise the drive. Refer to shipping weights on
the packing slip enclosed with the shipment.
2. Do not pass ropes or cables through the support holes in the
lifting angles. Use slings with safety hooks or shackles.
3. Select or adjust the rigging lengths to compensate for an unequal
weight distribution of load and maintain the drive in an upright
position.
4. To reduce the tension on the rigging and the compressive load on
the lifting device, do not allow the angle between the lifting
cables/chains and vertical to exceed 45 degrees.
A T T E N T I O N A T T E N T I O N Drives may contain heavy equipment that could
be adversely affected by tilting.
45.0 Max
Figure 2.1 – Overhead Lifting