Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) - Classic Control - Manual (Page 172)

Commissioning 4-13
7000 “B” Frame 7000-UM150I-EN-P – June 2013
Drive Application Review
In order to ensure trouble free commissioning, it is necessary for all
involved in the start-up to familiarize themselves with the drive line-
up and application. Service on the equipment should not be
performed without a clear understanding of how the equipment has
been designed to function and how the equipment has been applied.
If questions arise that have not been addressed within this manual,
they can be addressed by contacting your local GMS office or by
contacting Medium Voltage Support directly.
Rockwell Automation Drive line-up Drawings
Prior to performing any service work on the drive line-up, the
electrical and dimensional drawings provided with the equipment
must be studied and understood. Within these drawings is detailed
information and instructions required for commissioning and
installation of the equipment including the following:
Dimensional Drawings
 Power cable termination locations
 Ground bus locations
 Shipping split locations
 Control and medium voltage power ratings
 Drive options
 Remote I/O protocol
 PLC options
 Motor and load specifications
 Drive power component selection ratings
 Heat exchanger ratings, connections
Electrical Drawings
 Contactor locations (electrically)
 Drive topology
 General notes
 Cable isolation ratings
 Symbol table
 Component designations
Device
Designations
Color Designations
Wire No.
Designations
SGCT
Designations
Ribbon Cable
Designations
Location of Relay
and Contactor
Contacts
Location of
Relays
Drawing Location
References
 Customer power and control wiring locations (electrically)
 Control and medium voltage power ratings
 Fuse ratings and locations (electrically)