Rockwell Automation 1793-OE2S FLEX INTEGRA ANALOG MOD - Manual (Page 16)

Publication 1793-6.5.1 - April 1999
2-4 How to Install Your Analog Module
6. To remove an Integra module, you must work from the right side and
remove one module at a time. To disengage a module from its neighbor,
place a common flat-bladed screwdriver between the 2 modules and turn
1/4 turn to separate the modules.
7. Then slide the module away from its left neighbor, and release the
locking lever to remove the module from the DIN rail.
ATTENTION: Do not remove this module under power.
Removing this module under power will break the electrical
backplane (flexbus) connections. This can cause personal injury
or property damage by:
• sending an erroneous signal to your system’s field devices
causing unintended machine motion
• causing an explosion in a hazardous environment
• breaking communication to modules beyond this module
41373