Event log tab, Table 20 - settings for event log views, Figure 29 - settings for event log views – Rockwell Automation 1756-RMxx ControlLogix Enhanced Redundancy System User Manual User Manual
Page 120

120
Rockwell Automation Publication 1756-UM535D-EN-P - November 2012
Chapter 6
Configure the Redundancy Modules
Event Log Tab
The Event Log tab provides a history of events that have occurred on the
redundant chassis.
These system events are indicated in the event logs:
• Qualification stages entered and completed
• Module insertion/removal
• Firmware errors
• Communication events and errors
• Configuration changes
• Other system events that affect qualification and synchronization
The Event Log tab can be customized to view the log specific to only one chassis
or the event logs of both redundant chassis. You can alter your view of the event
logs by changing the Auto-Update and Partner Log parameters.
Figure 29 - Settings for Event Log Views
IMPORTANT
The events logged in this tab are not always indicative of an error. Many of
the events logged are informational only.
To determine if additional action or troubleshooting is required in response
to an event, see the
table on
.
Table 20 - Settings for Event Log Views
Use this setting
To
Auto-Update
Keep the log from updating while you’re viewing it.
Partner Log
View only the event log for the module you are accessing.
Check On to keep the log updating automatically.
Check Close to view only the log of one redundancy module.