Rockwell Automation 1403-NDNET DeviceNet Communications Card Installation Instructions - Manual (Page 10)

Publication 1403-IN054A-EN-P - August 2001
1-4 Product Description
Figure 1.3 Installing Communication Card
7. Place the closure plate over the opening. Make sure the
DeviceNet connector shows through the opening in the closure
plate. Plug the DeviceNet connector into the DeviceNet port.
Secure closure plate with the two screws from the original blank
plate as shown in Figure 1.4. The closure plate extends
approximately 20 mm (0.80 inches) from the back of the Master
Module.
Figure 1.4 Installing Closure Plate
8. Apply Master Module control power.
Field Service
Considerations If the DeviceNet Communications Card requires service, please
contact your nearest Rockwell Automation Sales Office. To minimize
your inconvenience, the initial installation should be performed in a
manner which makes removal easy.
TIP
Refer to Appendix D for screw torque requirements
and wire sizes.