Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 89)

Chapter
8
Viewing the Module’s Web Pages
Chapter 8 provides instructions on how to monitor the module and
connected SCANport drive using the module’s web interface.
Future enhancements may result in web pages that look different than
the examples shown in this chapter.
After configuring the module, you can view its web pages. These pages
present information about the module, and the drive to which it is
connected.
The module can be configured to automatically send e-mail messages to
desired addresses when selected drive faults or warnings occur and/or
are cleared, and/or when the module takes a communication or idle fault
action. For more details, see the
Configure E-mail Notification Web Page
section in this chapter.
Bit 0 of Parameter 65 - [Web Features] can be used to protect the
configured settings for e-mail notification. Refer to
Chapter 3 , Setting
Web Features Access for more information.
Topic Page
Accessing the Module’s Web Home Page 8-1
Process Display Pop-up Windows 8-5
TCP/IP Configuration Web Page 8-6
Configure E-mail Notification Web Page 8-7
SCANport Device Information Pages 8-9
Accessing the Module’s Web Home Page
TIP: By default the module web pages are disabled. To enable the web
pages, set the Web Pages Switch (SW2 in
Figure 2.1 ) to its “Enable
Web” position and then reset the module.