Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 103)

Module Parameters B-3
15
16
17
18 [IP Addr Act 1]
[IP Addr Act 2]
[IP Addr Act 3]
[IP Addr Act 4]
Displays the actual IP address being used by the
module. Default: 0
Default: 0
Default: 0
Default: 0
Minimum: 0
Maximum: 255
Type: Read Only
19
20
21
22 [Subnet Act 1]
[Subnet Act 2]
[Subnet Act 3]
[Subnet Act 4]
Displays the actual subnet mask being used by the
module. Default: 0
Default: 0
Default: 0
Default: 0
Minimum: 0
Maximum: 255
Type: Read Only
23
24
25
26 [Gateway Act 1]
[Gateway Act 2]
[Gateway Act 3]
[Gateway Act 4]
Displays the actual gateway address being used
by the module. Default: 0
Default: 0
Default: 0
Default: 0
Minimum: 0
Maximum: 255
Type: Read Only
27 [EN Rate Cfg]
Configures the network data rate at which the
module communicates. (Updates Parameter 28 -
[EN Rate Act] after reset.) Default: 0 = Autodetect
Values 0 = Autodetect
1 = 10 Mbps Full
2 = 10 Mbps Half
3 = 100 Mbps Full
4 = 100 Mbps Half
Type: Read/Write
Reset Required: Yes
Parameter
No. Name and Description
Details
255 . 255 . 255 . 255
[IP Addr Act 1]
[IP Addr Act 2]
[IP Addr Act 3]
[IP Addr Act 4]
255 . 255 . 255 . 255
[Subnet Act 1]
[Subnet Act 2]
[Subnet Act 3]
[Subnet Act 4]
255 . 255 . 255 . 255
[Gateway Act 1]
[Gateway Act 2]
[Gateway Act 3]
[Gateway Act 4]