Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 14)

1-2 Getting Started
The EtherNet/IP-to-SCANport module features the following:
• The module is an external module only. It requires DC power from
either an appropriate DC power source or AC-to-DC converter.
Connectors for both are provided.
• A number of configuration tools can be used to configure the module
and connected drive. These include drive-configuration software tools
such as DriveExplorer (version 4.03 or higher) or DriveExecutive
(version 3.01 or higher). In addition, you can use a BOOTP server to
configure some of the network features on the module (for example,
the IP address).
• Status indicators report the status of the drive, module, and network.
• I/O, including Logic Command/Reference and up to four pairs of
Datalinks, may be configured for your application using parameters.
• Explicit messages (parameter read/write, etc.) are supported.
• Master-Slave and/or Peer-to-Peer hierarchies can be set up so that the
module and connected SCANport drive transmit data to and from a
scanner and/or another SCANport drive on the network.
• User-defined fault actions determine how the module and SCANport
drive respond to communication disruptions on the network.
• Each module has Web pages that display information about the
module and the connected drive.
• The module can be configured to send e-mail messages to desired
addresses when selected drive faults occur and/or are cleared, and/or
when the module takes a communication or idle fault action.
Features