Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 143)

Appendix
E
N-File Addresses
Appendix E provides information on the N-File addresses used when
accessing the PCCC object or the DF-1 serial port. When using
messages, you can use the N-File addresses to locate information about
the module or SCANport product.
The 1203-EN1 module supports the N-File addresses shown below:
Address N-File Addresses
N10:0 Number of SCANport product parameters
N10:1 – 999 SCANport product parameters 1 – 999 (value only)
N11:0 – 999 SCANport product parameters 1000 – 1999 (value only)
N12:0 – 999 SCANport product parameters 2000 – 2999 (value only)
N13:0 Number of SCANport module 1203-EN1 parameters
N13:1 – 999 SCANport module 1203-EN1 parameters 1 – 999 (value only)
N30:1 – 999 SCANport product parameters 1 – 999 (all information — read only)
N31:0 – 999 SCANport product parameters 1000 – 1999 (all information — read only)
N32:0 – 999 SCANport product parameters 2000 – 2999 (all information — read only)
N33:1 – 999 SCANport module parameters 1 – 999 (all information — read only)
N40:0 – 63 Block Transfer Emulation file
N41:0 – 9 Control (Logic Command, Reference, datalink) registers – see page C-16
N42:3 Control, control timeout
N42:7 Module Port # — The SCANport module port number the module is
connected to on the SCANport product
N42:8 Reserved for future use — Always zero
N50:0 Number of SCANport product parameters
N50:1 – 249 SCANport product parameters 1 – 249 (value only)