Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 45)

Chapter
4
Configuring the Scanner or Bridge
Chapter 4 provides instructions on how to configure a ControlLogix
bridge to communicate with the module and connected 1305 drive.
After the module is configured, the connected drive and module will be a
single node on the network. This chapter provides the steps that are
needed to configure a simple network like the network in
Figure 4.1 . In
our example, we will configure a 1756-ENBT bridge to communicate
with a drive using Logic Command/Status, Reference/Feedback, and
four 16-bit datalinks over the network.
Figure 4.1 Example EtherNet/IP Network
Topic Page
Example Network 4-1
Adding a Bridge or Scanner to the I/O Configuration 4-2
Adding the Module and Drive to the I/O Configuration 4-4
Saving the Configuration 4-7
Example Network
JOG
ESC SEL
ControlLogix Controller
with 1756-ENBT Bridge
Computer with
Ethernet/IP Connection
1305 Drive
Switch
1203-EN1
EtherNet/IP
Module