Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 20)

2-2 Installing the Module
Set the Web Pages Switch (SW2) to enable or disable the module web
pages (see
Figure 2.1 and setting descriptions below). By default, the
module web pages are disabled. For complete details on module web
pages, see
Chapter 8 , Viewing the Module’s Web Pages .
Figure 2.1 Setting Web Pages Switch
!
ATTENTION: Risk of equipment damage exists. The EtherNet/IP
module contains ESD (Electrostatic Discharge) sensitive parts that can
be damaged if you do not follow ESD control procedures. Static control
precautions are required when handling the module. If you are
unfamiliar with static control procedures, refer to Guarding Against
Electrostatic Damage, Publication 8000-4.5.2.
SW2 Setting Description
Up position
(UP = OFF) Disables the module web pages (default setting).
Down position
(DN = ON) Enables the module web pages.
+ -
1 2 O
N
Serial SCANport
DC
ADP DC + -
1 2 O
N
UNUSED
SWITCH
WEB PAGES
SWITCH Enable Web
Position
Disable Web
Position