Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module - Manual (Page 43)

Configuring the Module 3-17
The following parameters provide information about how the module is
configured. You can view these parameters at any time using
DriveExplorer (version 4.03 or higher) or DriveExecutive (version 3.01
or higher) software.
Viewing the Module Configuration
Param Number Name Description
28 EN Rate Act The data rate used by the module.
15 – 18 IP Addr Act 1 – 4 The actual IP address used by the module.
19 – 22 Subnet Act 1 – 4 The actual subnet mask used by the module.
23 – 26 Gateway Act 1 – 4 The actual gateway address used by the module.
33 SP I/O Act The Reference/Feedback and Datalinks used by
the module. This value is the same as Parameter
32 - [SP I/O Cfg] unless the parameter was
changed and the module was not reset.
58 Peer Inp Status The status of the consumed peer input connection:
Values
0 = Off
1 = Waiting
2 = Running
3 = Faulted