Rockwell Automation 1203-EN1 EtherNet/IP-to-SCANport Module User Manual
Rockwell Automation Equipment
Table of contents
Document Outline
- Front Cover
- Summary of Changes
- Table of Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Configuring the Module
- Configuration Tools
- Using DriveExplorer Software
- Using BOOTP
- Setting the IP Address, Subnet Mask, and Gateway Address
- Setting the Data Rate
- Setting the I/O Configuration
- Setting the Reference Adjustment
- Selecting Master-Slave or Peer-to-Peer
- Setting a Fault Action
- Setting Web Features Access
- Resetting the Module
- Viewing the Module Configuration
- Configuring the Module
- Chapter 4
- Chapter 5
- Chapter 6
- Chapter 7
- Chapter 8
- Appendix A
- Appendix B
- Appendix C
- Appendix D
- Appendix E
- Appendix F
- Supported Emulated Block Transfer Commands
- What is Emulated Block Transfer
- Supported Emulated Block Transfer Commands
- Emulated Block Transfer Status Word
- Parameter Value Read
- Parameter Value Write
- Parameter Read Full
- Product ID Number Read
- Scattered Parameter Value Read
- Scattered Parameter Value Write
- NVS Functions
- Fault Command Write
- Fault Queue Entry Read Full
- Fault Queue Size
- Trip Fault Queue Number
- Supported Emulated Block Transfer Commands
- Glossary
- Index
- Back Cover