Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module User Manual
Rockwell Automation Equipment
Table of contents
Document Outline
- PowerFlex 20-750-ENETR Dual-port EtherNet/IP Option Module User Manual
- Important User Information
- Table of Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Configuring the Option Module
- Configuration Tools
- Using the PowerFlex 20-HIM- A6 or 20-HIM-C6S HIM to Access Parameters
- Setting the Option Module Node Address
- Setting the Data Rate
- Selecting Master-Slave or Peer-to-Peer Hierarchy (Adapter mode only)
- Setting a Fault Action (Adapter mode only)
- Setting Web Page Access
- Resetting the Option Module
- Restoring Option Module Parameters to Factory Defaults
- Viewing the Option Module Status Using Parameters
- Updating the Option Module Firmware
- Configuring the Option Module
- Chapter 4
- Chapter 5
- Chapter 6
- Using Explicit Messaging (Adapter mode only)
- About Explicit Messaging
- Performing Explicit Messaging
- ControlLogix Controller Examples
- ControlLogix Controller Example Ladder Logic Program to Read a Single Parameter
- ControlLogix – Formatting a Message to Read a Single Parameter
- ControlLogix Controller Example Ladder Logic Program to Write a Single Parameter
- ControlLogix – Formatting a Message to Write a Single Parameter
- ControlLogix Controller Example Ladder Logic Program to Read Multiple Parameters
- ControlLogix – Formatting a Message to Read Multiple Parameters
- ControlLogix Controller Example Ladder Logic Program to Write Multiple Parameters
- ControlLogix – Formatting a Message to Write Multiple Parameters
- ControlLogix Controller – Explanation of Request and Response Data for Read/Write Multiple Messaging
- Using Explicit Messaging (Adapter mode only)
- Chapter 7
- Chapter 8
- Viewing Option Module Web Pages
- Appendix A
- Appendix B
- Appendix C
- Appendix D
- Glossary
- Index
- Back Cover / Publication 750COM-UM008A-EN-P July 2012