Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 19)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 19
Installing the Option Module Chapter 2
Setting the Operating Mode The option module can be operated in Adapter mode (default) or Tap mode. For
information about the operating modes, see
Option Module Operating Modes
on page 11 .
Before installing the option module, set its Operating Mode Jumper J4 ( Figure 1 )
for the desired mode of operation.
Figure 1 - Setting Operating Mode Jumper J4
TIP If Operating Mode Jumper J4 is missing, the option module operates in the
Adapter mode.
IMPORTANT A new jumper setting is recognized only when power is applied to the option
module, or the module is reset. If you change a jumper setting, cycle power to
the drive or reset the module to apply the change.
MODE
ADPTR TA
P
J4
Adapter Mode
Jumper Position
(default)
Tap Mode
Jumper Position