Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 9)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 9
Chapter
1
Getting Started
The 20-750-ENETR Option Module is intended for installation into a
PowerFlex 750-Series drive and is used for network communication.
Components
Topic Page
Components 9
Features 10
Option Module Operating Modes 11
Compatible Products 13
Required Equipment 13
Safety Precautions 14
Quick Start 15
➊
➋
➌
➍
➎
➏
0
5 4
9
3 8 2
7
1
6
0
5 4
9
3 8 2
7
1
6
0
5 4
9
3 8 2
7
1
6
MODE
ADPTR TA
P
J4
Item Part Description
➊ Status Indicators Four status indicators that indicate the
status of the option module and network
communication. See
Chapter 7 ,
Troubleshooting.
➋ Node Address
Switches Sets the network node address of the
option module when not using:
• A BOOTP or DHCP server
• Option module parameters
See
Setting the Node Address on page 20 .
➌ Operating Mode
Jumper (J4) Selects the mode in which the option
module operates. See
Setting the
Operating Mode on page 19 .
➍ ENET1 Network
Port RJ-45 connector for the Ethernet network
cable. The connector is CAT-5 compliant
to ensure reliable data transfer on
100Base-TX Ethernet connections. Either
port may be used in Adapter mode.
➎ ENET2 Network
Port
➏ ENET3 (DEVICE)
Port (PowerFlex
755 only) RJ-45 connector to connect the short
Ethernet cable (provided with the option
module) to the Ethernet port on the
PowerFlex 755 drive embedded EtherNet/
IP adapter. This is intended for ‘Integrated
Motion on the EtherNet/IP network’ data
transfer.
Component Side View Top View