Parameters for tap mode operation, Device parameters—tap mode – Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module User Manual
Page 150
150
Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
Appendix B
Option Module Parameters
Parameters for Tap Mode
Operation
This section contains a list of
Device parameters available when the option
module is operated in Tap mode.
Device Parameters—Tap Mode
Parameter
No.
Name and Description
Details
01
[Operating Mode]
Displays the option module’s operating mode set with the
Operating Mode Jumper J4 (
).
Values:
0 = Adapter
1 = Tap
Type:
Read Only
02
[Port Number]
Displays the drive port into which the option module is installed.
Typically, this is Port 4, 5 or 6.
Minimum:
4
Maximum:
6
Type:
Read Only
03
[Reserved]
04
[Reserved]
05
[Net Addr Sel]
Selects the source from which the option module’s node address
is taken when the Node Address switches (
)
are not being used (that is, switches set to any value other than
001…254 or 888).
Default:
3 = DHCP
Values:
1 = Parameters
2 = BOOTP
3 = DHCP
Type:
Read/Write
Reset Required:
Yes
06
[Net Addr Src]
Displays the source from which the option module’s node address
is taken.
Values:
0 = Switches
1 = Parameters
2 = BOOTP
3 = DHCP
Type:
Read Only
07
08
09
10
[IP Addr Cfg 1]
[IP Addr Cfg 2]
[IP Addr Cfg 3]
[IP Addr Cfg 4]
Sets the IP address bytes for the option module’s network
address when Device Parameter 05 - [Net Addr Sel] is set to
“1” (Parameters) and the Node Address switches (
) are not being used (that is, switches set to any value
other than 001…254 or 888).
Default:
0
Default:
0
Default:
0
Default:
0
Minimum:
0
Maximum:
255
Type:
Read/Write
Reset Required:
Yes
255 . 255 . 255 . 255
[IP Addr Cfg 1]
[IP Addr Cfg 2]
[IP Addr Cfg 3]
[IP Addr Cfg 4]