Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 63)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 63
Configuring the I/O Chapter 4
12. Click Set to save the Port Configuration information which sets the
corresponding offline Subnet Cfg x and Gateway Cfg x parameters in the
option module.
13. Click OK on the New Module dialog box.
The new node (“My_PowerFlex_753_Drive” in this example) now
appears under the bridge (“My_EtherNet_IP_Bridge” in this example) in
the I/O Configuration folder. If you double-click the Controller Tags, you
will see that module-defined data types and tags have been automatically
created (
Figure 11 and Figure 12 ). Note that all tag names are defined and
Datalinks include the assigned drive parameter name. After you save and
download the configuration, these tags allow you to access the Input and
Output data of the drive via the controller’s ladder logic.
Figure 11 - Controller Input Tags
Enable BootP When this box is checked, BOOTP is enabled in the option module and will ignore the IP
address set in the General tab. When unchecked, the controller uses the set IP address.
This is another method to enable/disable BOOTP in the option module. For this
example, leave this box unchecked.
Box Setting