Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 139)

Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012 139
Appendix
B
Option Module Parameters
This appendix provides information about the option module parameters.
Parameter Types The option module has two types of parameters:
• Device parameters are used to configure the option module to operate on
the network.
Device parameters, when viewed using DriveExplorer or
DriveExecutive, appear below the 20-750-ENETR listing in the treeview
in a separate Device Parameters folder. When viewed with the 20-HIM-
A6 or 20-HIM-C6S HIM, these parameters appear in the DEV PARAM
folder.
• Host parameters are used to configure the option module Datalink transfer
and various fault actions with the drive.
Host parameters, when viewed
using DriveExplorer or DriveExecutive, appear below the 20-750-ENETR
listing in the treeview in a separate Host Parameters folder. When viewed
with the 20-HIM-A6 or 20-HIM-C6S HIM, these parameters appear in
the HOST PARAM folder.
Topic Page
Parameter Types 139
About Parameter Numbers 140
How Parameters Are Organized 140
Parameters for Adapter Mode Operation 140
Parameters for Tap Mode Operation 150
IMPORTANT Some Device parameters are not applicable when operating the option
module in Adapter mode while others are not applicable in Tap mode.
Therefore, these non-applicable parameters are labeled “Reserved” in
the Adapter Mode Operation and Tap Mode Operation parameter
tables in this appendix.
IMPORTANT When operating the option module in Tap mode, Host parameters are
NOT supported.