Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module User Manual
Page 50
50
Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
Chapter 3
Configuring the Option Module
Restoring Option Module
Parameters to Factory
Defaults
As an alternate reset method, you can restore the option module parameters by
using a MEMORY folder menu item instead of using
Device Parameter 25 -
[Reset Module]
described in
Resetting the Option Module on page 49
. The
MEMORY folder method provides two ways to restore the option module
Device and Host parameters:
•
ALL—restores ALL option module
Device and Host parameters to their
factory default values.
•
MOST—restores MOST option module
Device and Host parameters—
except the following which are used for network setup:
–
Device Parameter 05 - [Net Addr Sel]
–
Device Parameters 07 through 10 - [IP Addr Cfg 1-4]
–
Device Parameters 11 through 14 - [Subnet Cfg 1-4]
–
Device Parameters 15 through 18 - [Gateway Cfg 1-4]
–
Device Parameter 19 - [Net Rate Cfg 1]
–
Device Parameter 21 - [Net Rate Cfg 2]
–
Device Parameter 23 - [Net Rate Cfg 3] (Tap mode only)
Follow these steps to restore option module
Device and Host parameters to their
factory default values.
1.
Access the Status screen, which is displayed on HIM powerup.
2.
Use the
or
key to scroll to the Port in which the option
module is installed.
3.
Press the
key to display its last-viewed folder.
4.
Use the
or
key to scroll to the MEMORY folder.
5.
Use the
or
key to select Set Defaults.
6.
Press the
(Enter) key to display the Set Defaults pop-up box.
7.
Press the
(Enter) key again to display the warning pop-up box to
reset
Device and Host parameters to their factory default values.
8.
Press the MOST
soft key to restore MOST Device and Host parameters to
factory defaults or press the ALL
soft key to restore ALL parameters. Or
IMPORTANT
When operating the option module in Tap mode, Host parameters are NOT
supported, so only Device parameters are reset to their factory default values.
00
Stopped
0.00 Hz
AUTO
Host Drive
240V
4.2A
Rev 3.002 Ser. A
ESC
REF
TEXT
F
PAR#