Rockwell Automation 20-750-ENETR PowerFlexDual-Port EtherNet/IP Option Module - Manual (Page 136)

136 Rockwell Automation Publication 750COM-UM008A-EN-P - July 2012
Chapter 8 Viewing Option Module Web Pages
Viewing Web Pages in Tap
Mode In Tap mode, the option module has a different set of web pages than those
shown when operated in Adapter mode.
1. On a computer with access to the EtherNet/IP network on which the
drive/option module is installed, launch a web browser such as Microsoft™
Internet Explorer software, version 5.0 or later.
The computer can access option module web pages if it is connected to any
of the following:
•
The same network as the drive/option module
• A network with access to the drive/option module network via a
gateway device (for example, a router)
2. In the Address box, type the IP address of the option module
3. Press ENTER.
The option module Tap mode web Home Page ( Figure 49 ) appears.
Figure 49 - Tap Mode Web Home Page Example
4. In the navigation pane, click Diagnostics to display links to the following
web pages that contain the listed information.
IMPORTANT From the browser’s View menu, choose Refresh to always re-display
the option module Home Page while viewing any of the module’s
other web pages.
Web Pages – Tap Mode Information
Diagnostic Overview • Module resource utilization
• Web server read and write hits
• Module settings
• Ring status
• Network management features
Network Settings • Network interface details, such as IP address and subnet mask
• Ethernet interface configuration method
• Ethernet port details
Ethernet Statistics • Ethernet counters
• Ethernet port details
• Error information
Ring Statistics Ring supervisor, configuration, and fault details